Steps Necessary To Pass The 350-601 Exam from Training Expert TestKingsIT
Valid Way To Pass CCNP Data Center's 350-601 Exam
NEW QUESTION # 156 
Refer to the exhibit An engineer must configure fabric binding on a Cisco MDS 9000 Senes Switch to match the output Which fabric database configuration accomplishes this goal?
- A. Option B
- B. Option C
- C. Option A
- D. Option D
Answer: D
NEW QUESTION # 157
A new employee must be granted access to add VLANs into an existing Cisco UCS Manager and configure NTP synchronization with date and time zone settings. Which two privileges must be granted to the employee to complete the task? (Choose two.)
- A. Ext LAN Config (ext-lan-security)
- B. Service Profile Compute (Is-compute)
- C. Ext LAN Policy (ext-lan-policy)
- D. Service Profile Config (Is-config)
- E. Service Profile Network Policy (Is-network-policy)
Answer: A,C
Explanation:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/Reference-Docs/Privileges/4-1/b-UCSM-Privileges-4_1.pdf NTP can be configured only with EXT LAN Security.
VLAN can be added using the following privileges:
- Ext Lan Config (ext-lan-config)
- Ext Lan Policy (ext-lan-policy)
service profiles will add VLANs to vNICs only if they are configured to UCS manager. So service profile is not valid solution.
NEW QUESTION # 158
Which two statements about the process of upgrading an EPLD on a Cisco MDS 9000 series Switch are correct? (Choose two.)
- A. EPLDs can be upgraded only to the latest EPLD image.
- B. EPLD upgrades can be completed without powering down the module during the upgrade.
- C. The EPLDs for all the modules on a switch must be upgraded at the same time.
- D. EPLDs can be upgraded without replacing the hardware.
- E. An upgrade verification identifies the impact of each EPLD upgrade.
Answer: B,D
NEW QUESTION # 159
An engineer must configure OSPF in the data center. The external routes have already been redistributed OSPF. The network must meet these criteria:
* The data centre servers must reach services in the cloud and the services behind the redistributed routes.
* The exit point toward the internet should be propagated only when there is a dynamically learned default route from the upstream router.
Which feature is required?
- A. Default-information originate
- B. Totally stubby area
- C. Default-information originate always
- D. Stubby area
Answer: A
Explanation:
https://learningnetwork.cisco.com/s/question/0D53i00000Kt544/defaultinformationoriginate-always
NEW QUESTION # 160
Which action must be performed before renumbering a Cisco UCS chassis?
- A. Move the chassis to new ports on fibric interconnect.
- B. Decommission the chassis.
- C. Run the shut and no shut command on the connected ports.
- D. Re-acknowledge the chassis.
Answer: D
NEW QUESTION # 161
Refer to the exhibit.
What is the result of this series of commands?
- A. It updates the firmware on adapter 1/1/1 immediately.
- B. It reboots the server immediately.
- C. It activates the firmware on the next adapter boot.
- D. It verifies the firmware update on the server.
Answer: C
Explanation:
Section: Compute
NEW QUESTION # 162
Refer to the exhibit.
What is configured as a result of running these commands?
- A. IP Source Guard
- B. reverse lookup for outbound packets
- C. strict unicast RPF
- D. loose unicast RPF
Answer: C
Explanation:
Section: Network
NEW QUESTION # 163
An engineer is configuring VNTag between a virtualized server and a Cisco Nexus 5500 Series switch. Drag and drop the configuration steps from the into the correct order on the right.
Answer:
Explanation:
Explanation
install the virtualization feature set
Enable the virtualization feature set
Configure the port profile
Configure support for VNTag mode on the interface that connects to the server.
Configure the server to support NIV mode
Configure the vNICs of the server
NEW QUESTION # 164
Refer to the exhibit.
An engineer configures a new application profile using REST API and receives this error massage. Which method can be used before application profile can be configured?
- A. POST to aaaLogout
- B. GET to aaaListDomains
- C. POST to aaaLogin
- D. POST to aaaRefresh
Answer: C
NEW QUESTION # 165 
Refer to the exhibit. An engineer must monitor the Ethernet port and the corresponding VLAN traffic for the hyper4 device The SW3 device is a Cisco Nexus 7000 Series Switch Drag and drop the code snippets from the right into the boxes in the configuration to meet these requirements.
Answer:
Explanation:
NEW QUESTION # 166
What are two requirements when planning a Cisco HyperFlex All Flash standard cluster installation using three HX240c M5 servers? (Choose Two)
- A. The cluster deployment type must support a mix of HDD and SS
- B. If the Jumbo MTU option in the HyperFlex installer is enabled, then jumbo frames must also be enabled on the upstream switches.
- C. The servers must be discovered, unassociated, and connected to each fabric interconnect.
- D. The hypervisors must be installed to Cisco FlexFlash SD cards.
- E. If the Jumbo MTU option in the HyperFlex installer is enabled, then jumbo frames do not have to be enabled on the upstream switches.
Answer: B,C
Explanation:
https://www.cisco.com/c/en/us/td/docs/hyperconverged_systems/HyperFlex_HX_DataPlatformSoftware/ AdminGuide/3_5/ b_HyperFlexSystems_AdministrationGuide_3_5/b_HyperFlexSystems_AdministrationGuide_3_5_chapter_01111.html
NEW QUESTION # 167
When a strict CoPP policy is implemented, which statement describes an event during which packets are dropped?
- A. Fifteen SSH sessions remain connected to the switch.
- B. A large system image is copied to a switch by using the default VRF.
- C. A web server that is connected to a switch is affected by a DDoS attack.
- D. A ping sweep is performed on a network that is connected through a switch.
Answer: A
NEW QUESTION # 168
Which service profile is affected if the default host firmware policy in Cisco UCS Manager is changed?
- A. any service profile that uses a user-created host firmware policy
- B. any service profile that uses the global-default host firmware policy
- C. any service profile that has no host firmware policy defined
- D. any service profile that is not in the root sub-org
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/GUI-User-Guides/Firmware- Mgmt/3-1/b_UCSM_GUI_Firmware_Management_Guide_3_1/ b_UCSM_GUI_Firmware_Management_Guide_3_1_chapter_011.html
NEW QUESTION # 169
An engineer is implementing an import operation in Cisco UCS Manager. What is the impact of performing this operation?
- A. Only a configuration file that was exported from the same Cisco UCS Manager can be imported.
- B. A configuration can be imported from a higher release to a lower release.
- C. Information can be modified on the management plane only.
- D. An import operation can be scheduled.
Answer: C
Explanation:
The import function is available for all configuration, system configuration, and logical configuration files. You can perform an import while the system is up and running. An import operation modifies information on the management plane only. Some modifications caused by an import operation, such as a change to a vNIC assigned to a server, can cause a server reboot or other operations that disrupt traffic. https://www.cisco.com/en/US/docs/unified_computing/ucs/sw/gui/config/guide/141/UCSM_GUI_Configuration_Guide_141_chapter43.html#concept_D789E16C90724AEFB99D565574E45AD5
NEW QUESTION # 170
The Cisco Nexus switch Generic Online Diagnostics policy for a PortLoopback test requires 10 consecutive failures to error disable the port. The customer wants to change it to 5 consecutive failures. Which configuration applies the changes for module 1 only?
- A. Option B
- B. Option C
- C. Option A
- D. Option D
Answer: D
Explanation:
Explanation
"mod all" is incorrect. "mod 1test" is incorrect. "publish event" is incorrect.
"mod 1 test" is correct. It is with "policy-default".
NEW QUESTION # 171
Refer to the exhibit.
Service degradation is reported on a VM that is deployed on a Cisco UCS blade server. The traffic from the vNIC is required to SPAN in both directions to a packet analyzer that is connected to UCS-A slot 2 port 12.
Which two commands are needed to complete the configuration? (Choose two.)
- A. UCS-A /eth-traffic-mon/fabric/eth-mon-session # activate
- B. UCS-A /org/service-profile/vnic/mon-src* # set direction both
- C. UCS-A /eth-traffic-mon/fabric/eth-mon-session* # create eth-mon-session/dest-interface 2 12
- D. UCS-A /org/service-profile/vnic/mon-src* # set direction receive transmit
- E. UCS-A /eth-traffic-mon/fabric/eth-mon-session' # create dest-interface 2 12
Answer: B,E
NEW QUESTION # 172
Refer to the exhibit.
Which setting must be configured to prevent reuse of passwords?
- A. History Count
- B. Change Count
- C. Change Interval
- D. No Change Interval
Answer: A
Explanation:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/GUI-User-Guides/Admin- Management/3-1/b_Cisco_UCS_Admin_Mgmt_Guide_3_1/ b_Cisco_UCS_Admin_Mgmt_Guide_3_1_chapter_011.html
NEW QUESTION # 173
Refer to the exhibit.
An engineer is implementing zoning on two Cisco MDS switches. After the implementation is finished, E Ports that connect the two Cisco MDS switches becomes isolated. What is wrong with the implementation?
- A. E Ports on both MDS switches must be configured as F ports for the zoning to function.
- B. Zones are local to the MDS switch and name service must be used to activate the connection between E ports.
- C. Zones must have the same name on both MDS switches for the E ports to function.
- D. Different zone set names must be configured on both MDS switches.
Answer: C
NEW QUESTION # 174
......
All 350-601 Dumps and Implementing Cisco Data Center Core Technologies (350-601 DCCOR) Training Courses: https://exampasspdf.testkingit.com/Cisco/latest-350-601-exam-dumps.html